The new Mercury M76m/1 (Mk. III) is a mono version of the M76m. The M76m is based on one of the most sought after vintage amplifier modules, the ‘Telefunken/Siemens’ V76m. These modules were used in European broadcast and recording studios in the 1960s. Later, after tube consoles where out of favor and replaced by smaller, more discrete transistor consoles, the V76 modules still lived on and were racked as outboard mic amps and used in studios around the world.

Inspired by the vintage tone and craftsmanship of the classic, the Mercury M76m (Mk. III) focuses on bringing back the sound, look and feel that inspired not only this product but this company to manufacture recording equipment and keep this and other beloved circuits alive to make more music for another generation. The new M76m (Mk. III) has a new look but same stellar tone and craftsmanship and is still proudly built in the USA.

The Mercury M76m is based on the module used in consoles which are very rare due to a minimal amount made. These amplifier modules have not been available new for more than 50 years, so working units have become extremely rare, very expensive and in some cases are now in need of much repair. Drawing on nearly 20 years experience repairing, rebuilding, and most importantly listening to the Telefunken/Siemens V76 modules it was Mercury's first priority to build a modern Studio Microphone Amplifier that sounds identical to the original. Mercury Recording Equipment Co. kept the integrity of the original circuit, the M76m has the same open, warm tonality created with the transformer balanced, dual stage, high gain amplifier, and uses four transformers and four tube per channel. With the addition normal modern features, such as: Phantom, Phase, as well as many new features such as: Level Control and High/Low Impedance switch never available on any module, or even custom racked units, the Mercury M76m is the benchmark of modern tube microphone amplifiers.

Features:

The Mercury M76m Gain Control of 0 to +60dB in 6dB increments, works in conjunction with the Level Control and Output Attenuation
The Level Control, which will work as a ‘fader’, increasing (clockwise) and decreasing (counter clockwise) the amount of gain from the first stage to the second stage of the amplifier - this also allows you the ability to add musical (tube) “break up” by decreasing your level (control) and increasing the (course) gain
The Output Attenuation Control (-0 to -10dB) has been added for even more control, including the ability shape tones in several different ways, if desired, which works well on electric guitar recordings
Impedance Select Switch for both high and low impedance devices, as well as all the staple features one expects from a modern piece of equipment were added. Phantom Power (on/off) , Phase (Polarity) Reverse, and our amazing sounding F.D.I. (FET Direct Input) Circuit
The Mercury FDI (FET Direct Input), a proprietary J-Fet circuit, based on a class-A tube topology
The Mercury FDI is designed to reproduce every nuance of a direct recording, while the circuit lets the tube or solid-state character of the amplifier determine the overall tone
The instrument DI signal is sent through the entire microphone preamp circuitry, including Mercury’s custom, massive input transformers, so that the individual character of each preamp comes through

Specifications:

Mic Input Impedance: Approx. 2k
Suggested Source Impedance: Approx. 200 ohms
DI Input Impedance: 2M ohms
Internal Output impedance: 30-50 ohms (depends on gain setting)
Suggested Minimum Load: 500 ohms
Frequency response: 20 Hz to 20 kHz +/- 0.5dB
Harmonic Distortion: All musically related low orders of harmonics, with no
significant order above 5th.
Tubes: 3x EF806s, 1x E83F, per channel
Rack Size: 2u

Mercury M76m1

$3,998 Dólares